Skip to main content

Show or hide content based on time or location

Show or hide content on your survey, page, or form based on when someone views it or where they are, using the Time target and Geo target blocks.

Written by Gareth Burroughes

Use the Time target block to show content only between certain dates, and the Geo target block to show content only to visitors in certain places. Anything you put inside the block follows its rules.


Before you start


Show content between certain dates

Use this for a time-limited sale, or a competition with fixed start and end dates.

  1. In EasyEditor, under Tools, drag Time target onto the canvas.

  2. Drag the blocks you want to show or hide into the Time target block.

  3. Select the settings icon on the Time target block. The Edit time settings panel opens.

  4. To hide the content until a date, set Hide before a date to Yes, then choose the date in Hide before.

  5. To hide the content after a date, set Hide after a date to Yes, then choose the date.

  6. To set a time as well as a date, select At a certain time and enter the time. The time uses your account's time zone.

  7. Select Apply.

To show content only during a set period, set both dates.


Show content in certain locations

Use this for a country-specific offer, or to reach people near your next event.

  1. In EasyEditor, under Tools, drag Geo target onto the canvas.

  2. Drag the blocks you want to show or hide into the Geo target block.

  3. Select the settings icon on the Geo target block. The Edit location settings panel opens.

  4. In Friendly name, enter a name for the block. It appears in the block's header in EasyEditor.

  5. For Location unavailable, choose Show or Hide to decide what visitors see when their location can't be found.

  6. On the map, use the square, circle, or polygon tool to draw the areas you want to target.

  7. Select Apply.

Visitors are located by GPS where possible. If GPS isn't available, Wi-Fi gives an approximate location. If neither is available, their IP address is used, which is the least accurate method.

Did this answer your question?